Differences

This shows you the differences between two versions of the page.

--- survey_of_talon_srx_breakouts [2019/05/02 23:47] – created tell
+++ survey_of_talon_srx_breakouts [2019/05/03 22:15] (current) – [Criteria for judging boards] tell
@@ Line 6: / Line 6: @@
   * https://www.andymark.com/products/talon-srx-analog-breakout-board
   * https://www.andymark.com/products/talon-srx-universal-breakout-board
+  * https://www.andymark.com/products/sentinel-interface-board-for-the-talon-srx
+  * http://www.revrobotics.com/rev-11-1278/
 ====== Custom boards from other teams ======
@@ Line 26: / Line 28: @@
   * power status LED
   * limit switch status LEDs
-  * 3-pin connectors (ground,power,signal) for active limit switches
+  * 3-pin connectors (ground,power,signal) for active limit switches like hall-effect sensors
-  * encoder status LED(s)
+  * encoder status LED(s). full set of three (A/B/index), or partial?
   * 10-pin male connector for hookup to 10-pin encoders, while still using limit switches
+  * somthing to aid in CAN bus daisy-chain hookup
+(TODO: discussion about which of these we think are important)
 ====== The giant table ======
+TODO: table listing all criteria for all breakout boards.